Customize your 2005 to 2011 Toyota Tacoma with a 3D printed Switch Pros SP9100 panel mount designed to replace one of the factory overhead console doors. This mount provides a clean and convenient location for your Switch Pros SP9100 while keeping the controls easily accessible.

PLEASE NOTE

This listing is for the 3D printed switch panel mount ONLY. The Switch Pros SP9100 switch panel is NOT included.

IMPORTANT POSITION COMPATIBILITY

Toyota used two different overhead console door locations, and they are NOT interchangeable. Please make sure to select the position you prefer before ordering.

SUNGLASS HOLDER POSITION

Located toward the rear of the overhead console

GARAGE DOOR OPENER POSITION

Located toward the front of the overhead console, closer to the windshield

IMPORTANT FOR DIGITAL TEMPERATURE DISPLAY MODELS

If your overhead console is equipped with the factory digital temperature display, this mount can ONLY be installed in the sunglass holder position closest to the rear of the vehicle.

SWITCH PANEL COMPATIBILITY

This mount is designed specifically for the Switch Pros SP9100 switch panel.

The SP9100 can be used to control auxiliary lighting, fog lights, air compressors, light bars, and other accessories.

FITMENT

Designed for:

• 2005 to 2011 Toyota Tacoma

MATERIAL AND FINISH

Each mount is 3D printed in black ASA for improved heat resistance and durability inside the vehicle.

The mount comes unfinished, unsanded, and unpainted, allowing you to install it as is or customize the finish to your preference.

As with all 3D printed products, minor layer lines, surface variations, or small cosmetic imperfections may be present. We do our best to provide a clean, durable, high quality print with every order.

INCLUDED

• 1x 3D printed Switch Pros SP9100 panel mount

NOT INCLUDED

• Switch Pros SP9100 switch panel

• Wiring or other accessories