Installation

Recommended Items:

• Quick detailer without wax (for cleaning the application area)
• Microfiber
• StickerFab Application Fluid or Soapy Water (1 drop dish soap per cup of water)
• Heat gun or hairdryer

2 item kit (microfiber, installation fluid)

Ideal install temperature is 75-85 degrees.  If it is warm, do the install in the shade.  Vice versa if it is cooler.  Clean the surface of the factory letters. 

First remove the protective paper from the top of the acrylic pieces.  There is a protective 3M adhesive paper on the bottom side that will be removed later.

Spray the surface again with StickerFab application fluid and do the same to the overlay as you peel it off the backing paper.  This fluid will let you align the material perfectly and prevent it from sticking to itself.  Once you get a proper alignment, you can squeegee out the fluid and bubbles. 

Test fit each letter and then remove the backing paper.  Re-align the piece on top of the OEM letter and make sure there is an even gap around the outer edge.  The acrylic pieces are larger than the OEM emblem to cover up the silver.  Once properly aligned, press down firmly.  Repeat until all of the letters are complete.